Easy methods to Flip a Navy Surplus Mauser Right into a Scout Rifle


The worst strategy to find out about corrosive ammo is to shoot some in your rifle after which let the gun sit for a couple of weeks. In my case, it was surplus 8mm machine-gun ammo that I’d shot by way of my Yugoslavian Mauser. After studying about how some navy primers can rust a gun, I ran to my secure and held the rifle’s barrel as much as the sunshine. What had as soon as been a shiny bore appeared like a mine shaft.

I scrubbed the barrel for hours with each solvent I might discover earlier than I noticed that my rifle would by no means be the identical. After which I noticed one thing else: I had nothing to lose. There wasn’t a factor I might do to the gun to devalue it additional. It was a clean canvas. So I clamped the rifle right into a padded vise and minimize away the whole lot that wasn’t the gun I needed.

On the time, I used to be itching to construct a customized rifle, however I didn’t have the instruments or the cash for it. Alternatively, navy surplus weapons have all the time been chopped up and cobbled into deer rifles by hobbyists, and I cherished the concept of hot-rodding an older gun. I knew there have been good and unhealthy examples on the market. With hacksaw in hand, I hoped I might no less than trend one thing in between.

Scout rifle in the bed of a pickup truck.
The creator minimize and topped the barrel of his scout rifle. Jarren Vink

I lopped off the top of the barrel, and it landed on my store ground with a clunk. There was no turning again after that. I squared up the face of the bore with a bastard file, checking my work in opposition to a do-it-yourself jig as I went. A crowning instrument would value as a lot as I’d paid for the rifle, so I made my very own with a piece of brass rod and a countersink bit. I minimize a crude however efficient crown with my electrical drill on the slowest setting. Then I went to work on the inventory.

I threw out the highest hand guard, shaved off as a lot wooden as doable, and rounded the tip of the fore-end. The wooden was saturated with Cosmoline, so I put it within the solar and wiped off the grease because it leaked from the pores. As soon as it was clear, I stippled the grip and fore-end with a Dremel instrument and completed the gun off with a scout scope, a Timney set off, and a paracord sling earlier than heading to the vary.

Learn Subsequent: My Truck Gun: The Answer

Given the corrosion and all my new modifications, I wasn’t certain if I might even get the gun to shoot on paper. Miraculously, it printed a 1 1⁄2-inch group at 50 yards. Once I tried to shoot farther, the scope ran out of elevation, so I shimmed the again ring with aluminum from a beer can. Then each shot I took on the 100-yard plate related—which was much better accuracy than I deserved. Once I bought dwelling, I cleaned the bore and put the gun proper the place it belonged—in a case behind the bench seat of my F-150.

This story was initially revealed in issue no. 3, vol. 126 of Area & Stream.





Source link

We will be happy to hear your thoughts

Leave a reply

LEGENDARY APPLIANCES
Logo
Reset Password
Compare items
  • Total (0)
Compare
0
Shopping cart